Viewtv Setup Instructions
1. Plug Viewtv device into the wall outlet.
2. Plug your Antenna (RF compatible only) into the Viewtv RF IN port
3. Plug the provided AV cable into the matching Viewtv converter box AV OUT port.
a.For HD support please use the provided HDMI Cable and plug into HDMI OUT port.
4.Plug the other end of the AV/HDMI cable into the TV's AV/HDMI IN port
RF/Coaxial cable is also compatible, please set your TV output to channel 3 Please NOTE IMPORTANT:
While this device DOES have limited QAM/Cable capability, it is NOT officially supported due to incompatibility issues with some cable providers.
a. Please do NOT purchase this device soley for QAM/Cable use. Please be advised that it will work ONLY with DECRYPTED channels. It may NOT work with all Cable providers.
b. Old TV's with analog tuners will NOT allow you to watch one channel and record another with this device.
c. To delete channels go to Select Menu, Program, enter password 000000
d. New HDTVs WILL allow you to watch one channel using TV's digital tuner and record another, but you MUST enable "Loop Through" Under MENU/ Channel Search/ Modulation.(Credit to Andy) IMPORTANT: European DVB-T RF signal is NOT supported and will NOT work! Please REMOVE Clear Plastic Covering from the top of Viewtv Box before use! It cause's box to overheat!
ATS/Broadcast television is 100% guaranteed to work & is fully supported
If you have any issues with your device please contact customer support provided on your warranty card. Wha's in the box
1 Viewtv AT-163 converter box
1 HomeWorx Flat Digital HD Antenna
1 wireless remote control
1 Viewtv 6 foot HDMI Cable
1 Composite cable